Radius-Server Source-Ip - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
18
276
Example
The following example configures the number of times the software searches all
RADIUS server hosts as 5.
switchxxxxxx(config)#
18.4
radius-server source-ip
Use the radius-server source-ip Global Configuration mode command to specify
the source IP address used for communication with RADIUS servers. Use the no
form of this command to restore the default configuration.
Syntax
radius-server source-ip {
no radius-server source-ip {
Parameters
source-ip-address—Specifies the source IP address.
Default Configuration
The source IP address is the IP address of the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
If there is no available IP interface of the configured IP source address, an error
message is issued when attempting to communicate with the IP address.
Example
The following example configures the source IP address used for communication
with all RADIUS servers to 10.1.1.1.
switchxxxxxx(config)#
radius-server retransmit
source-ip-address
}
source-ip-address
radius-server source-ip
78-21075-01 Command Line Interface Reference Guide
RADIUS Commands
5
}
10.1.1.1
Advertisement
Table of Contents
