Cisco 300 Series Cli Manual page 25

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Introduction

78-21075-01 Command Line Interface Reference Guide

The following example shows how to access Global Configuration mode and

return to Privileged EXEC mode:

switchxxxxxx#

switchxxxxxx# configure

switchxxxxxx(config)# exit

switchxxxxxx#

Interface or Line Configuration Modes

Various submodes may be entered from Global Configuration mode. These

submodes enable performing commands on a group of interfaces or lines.

For instance to perform several operations on a specific port or range of ports, you

can enter the Interface Configuration mode for that interface.

The following example enters Interface Configuration mode for ports gi 1 -5 and

then sets their speed:

switchxxxxxx#

switchxxxxxx# configure

switchxxxxxx(config)# interface range gi1-5

switchxxxxxx(config-if)#speed 10

switchxxxxxx(config-if)#exit

switchxxxxxx(config)#

The exit command returns to Global Configuration mode.

The following submodes are available:

Interface — Contains commands that configure a specific interface (port,

VLAN, port channel, or tunnel) or range of interfaces. The Global

Configuration mode command interface is used to enter the Interface