Cisco 300 Series Cli Manual page 409

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Address Table Commands

78-21075-01 Command Line Interface Reference Guide

ip-multicast-address—Specifies the group IP Multicast address.

add—Adds ports to the group.

remove—Removes ports from the group.

interface-list

nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen

to designate a range of ports.

port-channel-list

port-channel

nonconsecutive port-channels with a comma and no spaces. Use a hyphen

to designate a range of port channels.

Default Configuration

No Multicast addresses are defined.

Default option is add.

Command Mode

Interface Configuration (VLAN) mode

User Guidelines

To register the group in the bridge database without adding or removing ports or

port channels, specify the ip-multicast-address parameter only.

Static Multicast addresses can be defined on static VLANs only.

You can execute the command before the VLAN is created.

The following example registers the specified IP address to the bridge table:

switchxxxxxx(config)#

switchxxxxxx(config-if)#

The following example registers the IP address and adds ports statically.

switchxxxxxx(config)#

—Specifies a list of Ethernet ports. Separate

—Specifies a list of port channels. Separate

interface vlan

bridge multicast ip-address

interface vlan