Default-Router; Dns-Server - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
53
880
53.8
default-router
Use the default-router DHCP Pool Configuration mode command to configure the
default routerlist for a DHCP client.
Use the no form of this command to remove the default router.
Syntax
ip-address
default-router
no default-router
Parameters
ip-address—Specifies the IP address of a router.One IP address is required,
although up to eight addresses can be specified in one command line.
Command Mode
DHCP Pool Host Configuration mode
DHCP Pool Network Configuration mode
Default Configuration
No default router is defined.
User Guidelines
The router IP address should be on the same subnet as the client subnet.
Example
The following example specifies 10.12.1.99 as the default router IP address.
Console(config-dhcp)#
53.9
dns-server
Use the dns-server DHCP Pool Configuration mode command to configure the
Domain Name System (DNS) IP servers available to a DHCP client.
Use the no form of this command to remove the DNS serverlist.
Syntax
dns-server
ip-address
no dns-server
ip-address2
ip-address8
[
...
default-router
10.12.1.99
[
ip-address2
...
ip-address8
78-21075-01 Command Line Interface Reference Guide
DHCP Server Commands
]
]
Advertisement
Table of Contents
