Show Bridge Multicast Address-Table - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
29
436
VLAN
IPv4 Multicast Mode
Admin
---
----------
1
MAC-GROUP
11
IPv4-GROUP
12
IPv4-SRC-GROUP
29.28 show bridge multicast address-table
Use the show bridge multicast address-table EXEC mode command to display
Multicast MAC addresses or IP Multicast address table information.
Syntax
show bridge multicast address-table
{mac-multicast-address | ipv4-multicast-address | ipv6-multicast-address}] [format
{ip | mac}] [source {ipv4-source-address | ipv6-source-address}
Parameters
•
vlan-id
vlan-id
—Display entries for specified VLAN ID.
•
address —Display entries for specified Multicast address. The possible
values are:
-
mac-multicast-address—Specifies the MAC Multicast address.
-
ipv4-multicast-address—Specifies the IPv4 Multicast address.
-
ipv6-multicast-address—Specifies the IPv6 Multicast address.
•
format—(this applies if picked mac-multicast-address). then i can display it
either in mac or ip format) Display entries for specified Multicast address
format. The possible values are:
-
ip—Specifies that the Multicast address is an IP address.
-
mac—Specifies that the Multicast address is a MAC address.
•
source {ipv4-source-address | ipv6-source-address}—Specifies the source
address. The possible values are:
-
ipv4-address—Specifies the source IPv4 address.
-
ipv6-address—Specifies the source IPv6 address.
Oper
Admin
-----------
-----------
MAC-GROUP
MAC-GROUP
IPv6-GROUP
IPv4-GROUP
IPv6-SRC-GROUP
IPv4-SRC-GROUP
[vlan vlan-id] [address
78-21075-01 Command Line Interface Reference Guide
Address Table Commands
IPv6 Multicast Mode
Oper
-----------
MAC-GROUP
IPv6-GROUP
IPv6-SRC-GROUP
]
Advertisement
Table of Contents
