Power Inline Limit - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Power over Ethernet (PoE) Commands
78-21075-01 Command Line Interface Reference Guide
Default Configuration
Inline power traps are disabled.
Command Mode
Global Configuration mode
Example
The following example enables inline power traps.
switchxxxxxx(config)# power inline traps enable
25.6
power inline limit
Use the power inline limit Interface Configuration mode command to configure the
power limit per port on an interface. Use the no form of the command to return to
default.
Syntax
power
power inline limit
no power inline limit
Parameters
power—States the port power consumption limit in Milliwatts (Range:The
parameter range depends on the current working mode:In POE mode: 0-15400, In
POE+ mode: 0–30000)
Default Configuration
The default value is the maximum power allowed in the specific working mode:
15.4W.
•
In POE mode: 15.4W
•
In POE+ mode: 30W
Command Mode
Interface Configuration (Ethernet) mode
25
379
Advertisement
Table of Contents
