Show Lacp - Cisco Catalyst 2960-X Command Reference Manual
Layer 2
Hide thumbs
Also See for Catalyst 2960-X:
- Security configuration manual (498 pages) ,
- Hardware installation manual (34 pages) ,
- Getting started manual (25 pages)
Table of Contents
Advertisement
show lacp
show lacp
To display Link Aggregation Control Protocol (LACP) channel-group information, use the show lacp command
in user EXEC mode.
show lacp [channel-group-number] {counters| internal| neighbor| sys-id}
Syntax Description
channel-group-number
counters
internal
neighbor
sys-id
Command Default
None
Command Modes
User EXEC
Command History
Release
Cisco IOS 15.0(2)EX
Usage Guidelines
You can enter any show lacp command to display the active channel-group information. To display specific
channel information, enter the show lacp command with a channel-group number.
If you do not specify a channel group, information for all channel groups appears.
You can enter the channel-group-number to specify a channel group for all keywords except sys-id.
Examples
This is an example of output from the show lacp counters user EXEC command. The table that follows
describes the fields in the display.
Switch> show lacp counters
Port
---------------------------------------------------------------------
Channel group:1
Gi2/0/1
Gi2/0/2
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
58
(Optional) Channel group number. The range is 1 to 24.
Displays traffic information.
Displays internal information.
Displays neighbor information.
Displays the system identifier that is being used by LACP. The system
identifier consists of the LACP system priority and the switch MAC
address.
LACPDUs
Marker
Sent
Recv
Sent
Recv
19
10
0
0
14
6
0
0
Modification
This command was introduced.
Marker Response
LACPDUs
Sent
Recv
Pkts
Err
0
0
0
0
0
0
Layer 2 Commands
OL-29043 -01
- Quick Links:
- Layer 2 Commands
Hide quick links:
Advertisement
Table of Contents
