Permit (Mac Access-List Configuration) - Cisco ME 3800X Command Reference Manual
Hide thumbs
Also See for ME 3800X:
- Installation manual (80 pages) ,
- Software manual (956 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
Chapter 2
Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
permit (MAC access-list configuration)
To allow non-IP traffic to be forwarded if the conditions are matched, use the permit command in MAC
access-list configuration mode. To remove a permit condition from the extended MAC access list, use
the no form of this command.
Note
Though visible in the command-line help strings, appletalk is not supported as a matching condition.
Syntax Description
any
host src-MAC-addr |
src-MAC-addr mask
host dst-MAC-addr |
dst-MAC-addr mask
type mask
aarp
amber
cos cos
dec-spanning
decnet-iv
diagnostic
dsm
etype-6000
etype-8042
lat
lavc-sca
OL-28238-01
{permit | deny} {any | host src-MAC-addr | src-MAC-addr mask} {any | host dst-MAC-addr |
dst-MAC-addr mask} [type mask | cos cos | aarp | amber | dec-spanning | decnet-iv |
diagnostic | dsm | etype-6000 | etype-8042 | lat | lavc-sca | lsap lsap mask | mop-console |
mop-dump | msdos | mumps | netbios | vines-echo | vines-ip | xns-idp]
no {permit | deny} {any | host src-MAC-addr | src-MAC-addr mask} {any | host dst-MAC-addr |
dst-MAC-addr mask} [type mask | cos cos | aarp | amber | dec-spanning | decnet-iv |
diagnostic | dsm | etype-6000 | etype-8042 | lat | lavc-sca | lsap lsap mask | mop-console |
mop-dump | msdos | mumps | netbios | vines-echo |vines-ip | xns-idp]
Keyword to specify to deny any source or destination MAC address.
Defines a host MAC address and optional subnet mask. If the source
address for a packet matches the defined address, non-IP traffic from that
address is denied.
Defines a destination MAC address and optional subnet mask. If the
destination address for a packet matches the defined address, non-IP
traffic to that address is denied.
(Optional) Uses the Ethertype number of a packet with Ethernet II or
SNAP encapsulation to identify the protocol of the packet.
(Optional) Selects Ethertype AppleTalk Address Resolution Protocol that
maps a data-link address to a network address.
(Optional) Selects EtherType DEC-Amber.
(Optional) Selects an arbitrary class of service (CoS) number from 0 to 7
to set priority. Filtering on CoS can be performed only in hardware. A
warning message appears if the cos option is configured.
(Optional) Selects EtherType Digital Equipment Corporation (DEC)
spanning tree.
(Optional) Selects EtherType DECnet Phase IV protocol.
(Optional) Selects EtherType DEC-Diagnostic.
(Optional) Selects EtherType DEC-DSM.
(Optional) Selects EtherType 0x6000.
(Optional) Selects EtherType 0x8042.
(Optional) Selects EtherType DEC-LAT.
(Optional) Selects EtherType DEC-LAVC-SCA.
type is 0 to 65535, specified in hexadecimal.
•
mask is a mask of don't care bits applied to the Ethertype before
•
testing for a match.
Cisco ME 3800X and ME 3600X Switch Command Reference
permit (MAC access-list configuration)
2-205
Advertisement
Table of Contents
