Ip Igmp Profile - Cisco ME 3800X Command Reference Manual
Hide thumbs
Also See for ME 3800X:
- Installation manual (80 pages) ,
- Software manual (956 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
ip igmp profile
ip igmp profile
To create an Internet Group Management Protocol (IGMP) profile and enter IGMP profile configuration
mode, use the ip igmp profile command in global configuration mode. In enter IGMP profile
configuration mode, you can specify the configuration of the IGMP profile to be used for filtering IGMP
membership reports from a switchport. To delete the IGMP profile, use the no form of this command.
Syntax Description
profile number
Defaults
No IGMP profiles are defined. When configured, the default action for matching an IGMP profile is to
deny matching addresses.
Command Modes
Global configuration
Command History
Release
12.2(52)EY
Usage Guidelines
When you are in IGMP profile configuration mode, you can create the profile by using these commands:
•
•
•
•
•
You can apply an IGMP profile to one or more Layer 2 interfaces, but each interface can have only one
profile applied to it.
You can verify your settings by using the show ip igmp profile privileged EXEC command.
Examples
This example shows how to configure IGMP profile 40 that permits the specified range of IP multicast
addresses.
Switch(config)# ip igmp profile 40
Switch(config-igmp-profile)# permit
Switch(config-igmp-profile)# range 233.1.1.1 233.255.255.255
Cisco ME 3800X and ME 3600X Switch Command Reference
2-104
ip igmp profile profile number
no ip igmp profile profile number
The IGMP profile number being configured. The range is 1 to 4294967295.
Modification
This command was introduced.
deny: specifies that matching addresses are denied; this is the default condition.
exit: exits from igmp-profile configuration mode.
no: negates a command or resets to its defaults.
permit: specifies that matching addresses are permitted.
range: specifies a range of IP addresses for the profile. This can be a single IP address or a range
with a start and an end address.
When entering a range, enter the low IP multicast address, a space, and the high IP multicast address.
Chapter 2
Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
OL-28238-01
Advertisement
Table of Contents
