Snmp Mib Rep Trap-Rate - Cisco ME 3800X Command Reference Manual

Hide thumbs Also See for ME 3800X:

Table of Contents

snmp mib rep trap-rate

To configure the sending of Resilient Ethernet Protocol (REP) SNMP traps when there is a link

operational status or port role change, use the snmp mib rep trap-rate command in global configuration

mode. To disable sending of the REP trap, use the no version of the command.

Syntax Description

trap-rate value

Sending REP traps is disabled.

Command Modes

Global configuration

Command History

Usage Guidelines

Use this command to enable the switch to send REP specific traps corresponding to link operational

status changes and port role changes.

This example configures the switch to send REP traps at a rate of 10 per second:

Switch(config)# snmp mib rep trap-rate 10

Related Commands

show running config

snmp mib rep trap-rate value

no snmp mib rep trap-rate

Sets the number of REP traps sent per second. The range is from 0 to 1000. The

default is 0 (no limit imposed; a trap is sent at every occurrence).

Modification

This command was introduced.

Verifies that REP traps are configured.

Cisco ME 3800X and ME 3600X Switch Command Reference

snmp mib rep trap-rate