Cisco ME 3800X Command Reference Manual page 154

Hide thumbs Also See for ME 3800X:

Table of Contents

For more information about MPLS and VPLS, see the software configuration guide for this release.

This example shows how to configure a VLAN-based VPLS (VFI abc) between provider edge (PE)

switch PE1's VLAN 3 interface and switch PE2's VLAN 4 interface. PE1 has IP address 10.0.0.1/32,

and PE2 has IP address 20.0.01l/32.

Enter these commands on the PE1 switch:

Switch(config)# l2 vfi abc manual

Switch(config-vfi)# vpn id 123

Switch(config-vfi)# neighbor 20.0.0.1 encapsulation mpls

Switch(config-vfi)# exit

Switch(config)# interface vlan 3

Switch(config-if)# xconnect vfi abc

Enter these commands on the PE2 switch:

Switch(config)# l2 vfi abc manual

Switch(config-vfi)# vpn id 123

Switch(config-vfi)# neighbor 10.0.0.1 encapsulation mpls

Switch(config-vfi)# exit

Switch(config)# interface vlan 4

Switch(config-if)# xconnect vfi abc

Related Commands

Cisco ME 3800X and ME 3600X Switch Command Reference

Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands

Displays VFI error or event debug messages.

Displays detailed information about a VFI, including VFI

Configures a VPN for the VFI VPLS.

Attaches an interface to a VFI.