Service Password-Recovery - Cisco ME 3800X Command Reference Manual
Hide thumbs
Also See for ME 3800X:
- Installation manual (80 pages) ,
- Software manual (956 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
service password-recovery
service password-recovery
To enable the password-recovery mechanism (the default), use the service password-recovery
command in global configuration mode. This mechanism allows an end user with physical access to the
switch to press the break key on the console terminal to interrupt the boot process while the switch is
powering up and to assign a new password.
To disable part of the password-recovery functionality, use the no form of this command. When the
password-recovery mechanism is disabled, interrupting the boot process is allowed only if the user
agrees to set the system back to the default configuration.
Syntax Description
This command has no arguments or keywords.
Defaults
The password-recovery mechanism is enabled.
Command Modes
Global configuration
Command History
Release
12.2(52)EY
Usage Guidelines
As a system administrator, you can use the no service password-recovery command to disable some of
the functionality of the password recovery feature by allowing an end user to reset a password only by
agreeing to return to the default configuration. This provides configuration file security by ensuring that
only authenticated and authorized users have access to the configuration file and prevents users from
accessing the configuration file by using the password recovery process.
The password recovery procedure requires using a break key. After the switch performs power-on self
test (POST), the switch begins the autoboot process. The boot loader prompts the user for a break key
character during the boot-up sequence, as shown in this example:
You must enter the break key on the console terminal within 5 seconds of receiving the message that the
system will autoboot. A user with physical access to the switch presses the break key on the console terminal
within 5 seconds of receiving the message that flash memory is initializing. The System LED flashes
green until the break key is accepted. After the break key is accepted, the System LED turns off until
after the switch boots.
Cisco ME 3800X and ME 3600X Switch Command Reference
-4
service password-recovery
no service password-recovery
Modification
This command was introduced.
***** The system will autoboot in 5 seconds *****
Send a break key to prevent autobooting.
Chapter
OL-28238-01
Advertisement
Table of Contents
