Police Aggregate - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

Quality of Service (QoS) Commands

aggregate-policer policer1 96000 4800 exceed-action drop

not used by any policy map

39.16 police aggregate

Use the police aggregate Policy-map Class Configuration mode. command to

apply an aggregate policer to multiple class maps within the same policy map.

Use the no form of this command to remove an existing aggregate policer from a

This command is only available in QoS advanced mode.

aggregate-policer-name

police aggregate

aggregate-policer-name

no police aggregate

aggregate-policer-name—Specifies the aggregate policer name.

Command Mode

Policy-map Class Configuration mode.

User Guidelines

An aggregate policer can be applied to multiple classes in the same policy map.

An aggregate policer cannot be applied across multiple policy maps or interfaces.

Use the exit command to return to the Configuration mode. Use the end command

to return to the Privileged EXEC mode.

This command does not work in Layer 3 mode.

The following example applies the aggregate policer called Policer1 to a class

called class1 in a policy map called policy1 and class2 in policy map policy2.

switchxxxxxx(config)# qos aggregate-policer

policer1 124000 9600

exceed-action

switchxxxxxx(config)# policy-map

OL-32830-01 Command Line Interface Reference Guide