Power Over Ethernet (Poe) Commands; Power Inline - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Power over Ethernet (PoE) Commands
OL-32830-01 Command Line Interface Reference Guide
36.0
36.1
power inline
To configure the inline power administrative mode on an interface, use the power
inline Interface Configuration mode command.
Syntax
power inline
auto [
time-range
never
power inline
Parameters
•
auto—Turns on the device discovery protocol and applies power to the
device.
•
never—Turns off the device discovery protocol and stops supplying power
to the device.
•
time-range-name—Specifies a time range. When the time range is not in
effect the power is not supplied the attached device. If a time range is not
specified, there is no time range bounded to the port. (Range: 1–32
characters)
Default Configuration
The default configuration is set to auto.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The never parameter cannot be used with a time range.
time-range-name]
36
724
Advertisement
Table of Contents
