Sec-Level Minimum - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

User Guidelines

Use this command to change the global configuration specified by the

raguard router-preference

Use the disable keyword to disable of verification in both global or VLAN

configuration.

The following example defines an RA Guard policy named policy1, places the

switch in RA Guard Policy Configuration mode, and defines a minimum Default

Router Preference value of medium:

switchxxxxxx(config)#

switchxxxxxx(config-ra-guard)#

switchxxxxxx(config-ra-guard)# exit

25.63 sec-level minimum

To specify the minimum security level value within an Ipv6 ND Inspection policy,

use the sec-level minimum command in ND Inspection policy Configuration mode.

To return to the default, use the no form of this command.

sec-level minimum

no sec-level minimum

—Sets the minimum security level, which is a value from 0 through 7.

disable—Disables verification of security level parameter

Default Configuration

Policy attached to port or port channel: the value configured in the policy attached

to the VLAN.

Policy attached to VLAN: global configuration.

command on the port on which this policy applies.

ipv6 nd raguard policy policy1

router-preference minimum medium

OL-32830-01 Command Line Interface Reference Guide

IPv6 First Hop Security