Show Macro Auto Processing - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

parameter-name value

are the parameters of the built-in or user-defined macro defined in the

macro auto user smartport macro command

Default Configuration

The default value of parameter

For other parameters, the default value is the parameter's default value. For

instance, if the parameter is the native VLAN, the default value is the default native

Command Mode

Global Configuration mode

User Guidelines

By default, each Smartport type is associated with a pair of built-in macros: a

macro that applies the configuration and the anti macro (no macro) to remove the

configuration. The Smartport types are the same as the name of the

corresponding built-in Smartport macros, with the anti macro prefixed with no_.

The value of the parameter $voice_vlan cannot be changed by this command.

To change the parameters of a built-in macro:

switchxxxxxx(config)#

44.12 show macro auto processing

The show macro auto processing EXEC mode command displays information

about which protocols (CDP/LLDP) are enabled and which device types can be

detected automatically.

show macro auto processing

This command has no arguments or keywords.

—Specifies the parameter name and its value. These

$native_vlan

of the built-in Smartport macros is 1.

macro auto built-in parameters switch $native_vlan 2

OL-32830-01 Command Line Interface Reference Guide

Smartport Commands