Exec-Timeout; Line - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Line Commands
OL-32830-01 Command Line Interface Reference Guide
29.2 exec-timeout
To set the session idle time interval, during which the system waits for user input
before automatic logoff, use the exec-timeout Line Configuration mode command.
To restore the default configuration, use the no form of this command.
Syntax
minutes
exec-timeout
no exec-timeout
Parameters
•
minutes—Specifies the number of minutes. (Range: 0-65535)
•
seconds—(Optional) Specifies the number of seconds. (Range: 0-59)
Default Configuration
The default idle time interval is 10 minutes.
Command Mode
Line Configuration Mode
Example
The following example sets the telnet session idle time interval before automatic
logoff to 20 minutes and 10 seconds.
switchxxxxxx(config)#
switchxxxxxx(config-line)#
29.3 line
To identify a specific line for configuration and enter the Line Configuration
command mode, use the line Global Configuration mode command.
Syntax
{console | telnet | ssh}
line
seconds
[
]
line telnet
exec-timeout 20 10
29
640
Advertisement
Table of Contents
