Sntp Client Enable - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
9
239
Command Mode
Global Configuration mode
User Guidelines
Use the sntp broadcast client enable Interface Configuration mode command to
enable the SNTP Broadcast client on a specific interface.
After entering this command, you must enter the
sntp keyword for the command to be run. If this command is not run, the switch will
not synchronize with Broadcast servers.
Example
The following example enables SNTP Broadcast clients.
switchxxxxxx(config)#
9.12
sntp client enable
To enable the SNTP Broadcast and Anycast client, use the sntp client enable
command in Global Configuration mode. To restore the default configuration, use
the no form of this command.
Syntax
In switch mode:
sntp client enable
no sntp client enable
In router mode:
interface-id
sntp client enable
no sntp client enable
Parameters
•
interface-id
—Specifies an interface ID, which can be one of the following
types: Ethernet port, Port-channel or VLAN.
sntp broadcast client enable
interface-id
OL-32830-01 Command Line Interface Reference Guide
Clock Commands
clock source
command with the
Advertisement
Table of Contents
