Management Access-List - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Management ACL Commands
OL-32830-01 Command Line Interface Reference Guide
•
prefix-length
mask
IPv4 address prefix. The prefix length must be preceded by a forward slash
(/). This parameter is relevant only to IPv4 addresses. (Range: 0–32)
Default Configuration
No rules are configured.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with Ethernet, VLAN, and port-channel parameters are valid only if an IP
address is defined on the appropriate interface.
Example
The following example permits all ports in the ACL called mlist
switchxxxxxx(config)#
switchxxxxxx(config-macl)#
33.3 management access-list
To configure a management access list (ACL) and enter the Management
Access-list Configuration mode, use the management access-list Global
Configuration mode command. To delete an ACL, use the no form of this command.
Syntax
management access-list
no management access-list
Parameters
name—Specifies the ACL name. (Length: 1–32 characters)
Default Configuration
N/A
— Specifies the number of bits that comprise the source
management access-list mlist
switchpermit
name
name
33
700
Advertisement
Table of Contents
