Ipv6 Link-Local Default Zone; Ipv6 Nd Dad Attempts - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
27
615
27.9
ipv6 link-local default zone
Use the Ipv6 link-local default zone command to configure an interface to egress a
link local packet without a specified interface or with the default zone 0.
Use the no form of this command to return the default link local interface to the
default value.
Syntax
Ipv6 link-local default zone
no Ipv6 link-local default zone
Parameters
•
interface-id
—Specifies the interface that is used as the egress interface for
packets sent without a specified IPv6Z interface identifier or with the
default 0 identifier.
Default
By default, link local default zone is disabled.
Command Mode
Global Configuration mode
Example
The following example defines VLAN 1 as a default zone:
switchxxxxxx(config)#
27.10 ipv6 nd dad attempts
Use the ipv6 nd dad attempts command in Interface Configuration mode to
configure the number of consecutive neighbor solicitation messages that are sent
on an interface while duplicate address detection is performed on the Unicast
IPv6 addresses of the interface.
To return the number of messages to the default value, use the no form of this
command.
interface-id
ipv6 link-local default zone vlan1
OL-32830-01 Command Line Interface Reference Guide
IPv6 Commands
Advertisement
Table of Contents
