Snmp-Server Set - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Network Management Protocol (SNMP) Commands
OL-32830-01 Command Line Interface Reference Guide
Command Mode
Global Configuration mode
Example
The following example sets the device location to New_York.
switchxxxxxx(config)#
45.22 snmp-server set
To define SNMP MIB commands in the configuration file if a MIB performs an action
for which there is no corresponding CLI command, use the snmp-server set Global
Configuration mode command.
Syntax
variable-name name value
snmp-server set
Parameters
•
variable-name—Specifies an SNMP MIB variable name, which must be a
valid string.
•
value
name
—Specifies a list of names and value pairs. Each name and
value must be a valid string. In the case of scalar MIBs, there is only a single
name-value pair. In the case of an entry in a table, there is at least one
name-value pair, followed by one or more fields.
Default Configuration
None
Command Mode
Global Configuration mode
User Guidelines
Although the CLI can set any required configuration, there might be a situation
where an SNMP user sets a MIB variable that does not have an equivalent CLI
command. To generate configuration files that support those situations, the system
uses
snmp-server
set. This command is not intended for the end user.
snmp-server location New_York
[
name2 value2
...]
45
884
Advertisement
Table of Contents
