Table of Contents
Advertisement
34
751
switchxxxxxx(config)#
switchxxxxxx(config-line)#
34.2 exec-timeout
To set the session idle time interval, during which the system waits for user input
before automatic logoff, use the exec-timeout Line Configuration mode command.
To restore the default configuration, use the no form of this command.
Syntax
minutes
exec-timeout
no exec-timeout
Parameters
•
minutes—Specifies the number of minutes. (Range: 0-65535)
•
seconds—(Optional) Specifies the number of seconds. (Range: 0-59)
Default Configuration
The default idle time interval is 10 minutes.
Command Mode
Line Configuration Mode
Example
The following example sets the telnet session idle time interval before automatic
logoff to 20 minutes and 10 seconds.
switchxxxxxx(config)#
switchxxxxxx(config-line)#
34.3 line
To identify a specific line for configuration and enter the Line Configuration
command mode, use the line Global Configuration mode command.
line console
autobaud
seconds
[
]
line telnet
exec-timeout 20 10
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Line Commands
Advertisement
Table of Contents
