Table of Contents
Advertisement
44
889
44.4 show fiber-ports optical-transceiver
To display the optical transceiver diagnostics, use the show fiber-ports
optical-transceiver Privileged EXEC mode command.
Syntax
show fiber-ports optical-transceiver
Parameters
•
interface-id—(Optional) Specify an Ethernet port ID.
Default Configuration
All ports are displayed. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Example
ss
switchxxxxxx#
show fiber-ports optical-transceiver
Port
Temp
Voltage Current Output
[C]
[Volt]
----------- ------ ------- ------- ------- ------- ---
gi11
Copper
gi12
Copper
gi13
28
3.32
gi14
29
3.33
Temp
- Internally measured transceiver temperature
Voltage
- Internally measured supply voltage
Current
- Measured TX bias current
Output Power - Measured TX output power in milliWatts
Input Power
- Measured RX received power in milliWatts
LOS
- Loss of signal
[interface interface-id
Input
[mA]
Power
Power
[mWatt] [mWatt]
7.26
3.53
3.68
6.50
3.53
3.71
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
PHY Diagnostics Commands
]
LOS
No
No
Advertisement
Table of Contents
