Table of Contents
Advertisement
4
127
4.3
bridge multicast address
To register a MAC-layer Multicast address in the bridge table and statically add or
remove ports to or from the group, use the bridge multicast address Interface
(VLAN) Configuration mode command. To unregister the MAC address, use the no
form of this command.
Syntax
bridge multicast address {
interface-list
remove] {ethernet
no bridge multicast address
Parameters
•
mac-multicast-address | ipv4-multicast-address—Specifies the group
Multicast address.
•
add—(Optional) Adds ports to the group.
•
remove—(Optional) Removes ports from the group.
•
interface-list
ethernet
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
•
port-channel-list
port-channel
Separate nonconsecutive port-channels with a comma and no spaces; use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
interface-list
If ethernet
specifying add or remove, the default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the mac-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.
mac-multicast-address | ipv4-multicast-address}
| port-channel
mac-multicast-address
—(Optional) Specifies a list of Ethernet ports.
—(Optional) Specifies a list of port channels.
port-channel-list
or port-channel
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Address Table Commands
port-channel-list
}]
is specified without
[[add |
Advertisement
Table of Contents
