Table of Contents
Advertisement
36
775
36.15 lldp optional-tlv
To specify which optional TLVs are transmitted, use the lldp optional-tlv Interface
(Ethernet) Configuration mode command. To restore the default configuration, use
the no form of this command.
Syntax
tlv
tlv2
lldp optional-tlv
[
Parameters
•
tlv—Specifies the TLVs to be included. Available optional TLVs are:
port-desc, sys-name, sys-desc, sys-cap, 802.3-mac-phy, 802.3-lag,
802.3-max-frame-size, Power-via-MDI , 4-wirePower-via-MDI.
•
none—(Optional) Clear all optional TLVs from the interface.
If the 802.1 protocol is selected, see the command below.
Default Configuration
The following TLV are transmitted:
•
sys-name
•
sys-cap
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example specifies that the port description TLV is transmitted on
gi12.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
Link Layer Discovery Protocol (LLDP) Commands
tlv5
none
...
|
]
interface gi12
lldp optional-tlv port-desc
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Advertisement
Table of Contents
