Table of Contents
Advertisement
IGMP Proxy Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Use the no ip igmp-proxy ssm command to remove all defined ranges.
Example
The following example shows how to configure SSM service for the default IP
address range and the IP address ranges defined by access list list1:
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#
22.5 show ip igmp-proxy interface
To display information about interfaces configured for IGMP Proxy, use the show ip
igmp-proxy interface command in User EXEC mode or Privileged EXEC mode.
Syntax
show ip igmp-proxy interface [
Parameters
•
interface-id
—(Optional) Display IGMP Proxy information about the
interface.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
The show ip igmp-proxy interface command is used to display all interfaces
where the IGMP Proxy is enabled or to display the IGMP Proxy configuration for a
given interface.
Examples
Example 1. The following example displays IGMP Proxy status on all interfaces
where the IGMP Proxy is enabled:
ip access-list list1 permit 224.2.151.0/24
ip access-list list1 deny 224.2.152.141
ip access-list list1 permit 224.2.152.0/24
ip igmp-proxy ssm range list1
interface-id
]
22
482
Advertisement
Table of Contents
