Show Ip Arp Inspection Interface - Cisco Nexus 7000 Series Command Reference Manual
Hide thumbs
Also See for Nexus 7000 Series:
- Reference manual (746 pages) ,
- Configuration manual (536 pages) ,
- Hardware installation and reference manual (508 pages)
Table of Contents
Advertisement
show ip arp inspection interface
show ip arp inspection interface
To display the trust state and the ARP packet rate for the specified interface, use the show ip arp inspection
interface command.
Syntax Description
show ip arp inspection interfaceethernet slot/port| port-channel channel-number
ethernet slot /port
port-channel channel-number
Command Default
None
Command Modes
Any command mode
Command History
Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the trust state and the ARP packet rate for a trusted interface:
switch# show ip arp inspection interface ethernet 2/1
Interface
-------------
Ethernet2/46
switch#
Related Commands
Command
ip arp inspection vlan
show ip arp inspection
Cisco Nexus 7000 Series Security Command Reference
784
Modification
This command was introduced.
Trust State
Rate (pps)
-----------
----------
Trusted
15
(Optional) Specifies that the output is for an Ethernet
interface.
(Optional) Specifies that the output is for a
port-channel interface. Valid port-channel numbers
are from 1 to 4096.
Burst Interval
--------------
5
Description
Enables Dynamic ARP Inspection (DAI) for a
specified list of VLANs.
Displays the DAI configuration status.
Show Commands
Advertisement
Table of Contents
