Permit (Acl) - Cisco Nexus 7000 Series Command Reference Manual
Hide thumbs
Also See for Nexus 7000 Series:
- Reference manual (746 pages) ,
- Configuration manual (536 pages) ,
- Hardware installation and reference manual (508 pages)
Table of Contents
Advertisement
permit (ACL)
permit (ACL)
To enable a capture session for the access control entries (ACEs) of the access control list, use the permit
command.
permit protocol {"0-255"| ahp| eigrp| esp| gre| icmp| igmp| ip| nos| ospf| pcp| pim| tcp| udp}| {source|
addrgroup| any| host}| {destination| addrgroup| any| eq| gt| host| lt| neq| portgroup| range} capture
session session
Syntax Description
0-255
ahp
eigrp
esp
gre
icmp
igmp
ip
nos
ospf
pcp
pim
tcp
udp
source
addrgroup
any
host
Cisco Nexus 7000 Series Security Command Reference
534
(Optional) Specifies a protocol number.
(Optional) Specifies Authentication Header Protocol.
(Optional) Specifies Cisco's EIGRP routing protocol.
(Optional) Specifies encapsulation security payload.
(Optional) Specifies Cisco's GRE tunneling.
(Optional) Specifies Internet Control Message
Protocol.
(Optional) Specifies Internet Group Management
Protocol.
(Optional) Specifies any IP protocol.
(Optional) Specifies KA9Q NOS compatible IP over
IP tunneling.
(Optional) Specifies OSPF routing protocol.
(Optional) Specifies Payload Compression Protocol.
(Optional) Specifies protocol independent multicast.
Specifies Transport Control Protocol.
(Optional) Specifies User Datagram Protocol.
Source network address.
(Optional) Specifies the source address group.
(Optional) Specifies any source address.
(Optional) Specifies a single destination host.
P Commands
Advertisement
Table of Contents
