Neq - Cisco Nexus 7000 Series Command Reference Manual

Hide thumbs Also See for Nexus 7000 Series:

Table of Contents

neq

To specify a not-equal-to group member for an IP port object group, use the neq command. To remove a

not-equal-to group member from port object group, use the no form of this command.

[ sequence-number ] neq port-number

no {sequence-number| neq port-number}

Syntax Description

sequence-number

Command Default

Command Modes

IP port object group configuration

Command History

Usage Guidelines

A not-equal-to group member matches port numbers that are not equal to the port number specified in the

IP port object groups are not directional. Whether an neq command matches a source or destination port or

whether it applies to inbound or outbound traffic depends upon how you use the object group in an ACL.

This command does not require a license.

This example shows how to configure an IP port object group named port-group-05 with a group member

that matches traffic sent to any port except port 80:

switch# configure terminal

switch(config)# object-group ip port port-group-05

switch(config-port-ogroup)# neq 80

(Optional) Sequence number for this group member.

Sequence numbers maintain the order of group

members within an object group. Valid sequence

numbers are from 1 to 4294967295. If you do not

specify a sequence number, the device assigns a

number that is 10 greater than the largest sequence

number in the current object group.

Port number that this group member does not match.

Valid values are from 0 to 65535.

Modification

This command was introduced.

Cisco Nexus 7000 Series Security Command Reference