Cisco Nexus 7000 Series Command Reference Manual page 392

Hide thumbs Also See for Nexus 7000 Series:

Table of Contents

Usage Guidelines

To specify a subnet as a group member, use the following forms of this command:

[ sequence-number ] IPv6-address /network-prefix

To specify a single IP address as a group member, use any of the following forms of this command:

[ sequence-number ] host IPv6-address

[ sequence-number ] IPv6-address /128

Regardless of the command form that you use to specify a single IPv6 address, the device shows the

hostIPv6-address form of the group member when you use the show object-group command.

This command does not require a license.

This example shows how to configure an IPv6-address object group named ipv6-addr-group-A7 with two

group members that are specific IPv6 addresses and one group member that is the 2001:db8:0:3ab7:: subnet:

10.121.57.234/32

switch# configure terminal

switch(config)# object-group ipv6 address ipv6-addr-group-A7

switch(config-ipv6addr-ogroup)# host 2001:db8:0:3ab0::1

switch(config-ipv6addr-ogroup)# 2001:db8:0:3ab0::2/128

switch(config-ipv6addr-ogroup)# 2001:db8:0:3ab7::/96

switch(config-ipv6addr-ogroup)# show object-group ipv6-addr-group-A7

10 host 2001:db8:0:3ab0::1

20 host 2001:db8:0:3ab0::2

30 2001:db8:0:3ab7::/96

switch(config-ipv6addr-ogroup)#

Related Commands

object-group ipv6 address

show object-group

Cisco Nexus 7000 Series Security Command Reference

Configures an IPv6 address group.

Displays object groups.