Next-Server - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
DHCP Server Commands
78-21075-01 Command Line Interface Reference Guide
Syntax
netbios-node-type {b-node
no netbios-node-type
Parameters
•
b-node—Specifies the Broadcast NetBIOS node type.
•
p-node—Specifies the Peer-to-peer NetBIOS node type.
•
m-node—Specifies the Mixed NetBIOS node type.
•
h-node—Specifies the Hybrid NetBIOS node type.
Command Mode
DHCP Pool Host Configuration mode
DHCP Pool Network Configuration mode
Default Configuration
h-node (Hybrid NetBIOS node type).
Example
The following example specifies the client's NetBIOS type as mixed.
Console(config-dhcp)#
53.13 next-server
Use the next-server DHCP Pool Configuration mode command to configure the
next server (siaddr) in the boot process of a DHCP client. The client will connect,
using SCP/TFTP, to this server in order to download the boot file.
Use the no form of this command to remove the boot server.
Syntax
ip-address
next-server
no next-server
Parameters
ip-address—Specifies the IP address of the next server in the boot process,
which is typically a Trivial File Transfer Protocol (TFTP) server.
|
|
p-node
m-node
netbios node-type m-node
|
h-node}
53
883
Advertisement
Table of Contents
