Cisco 300 Series Cli Manual page 609

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Link Layer Discovery Protocol (LLDP) Commands

78-21075-01 Command Line Interface Reference Guide

ip-address—Specifies the static management address to advertise.

none—Specifies that no address is advertised.

automatic—Specifies that the software automatically selects a

management address to advertise from all the IP addresses of the product.

In case of multiple IP addresses, the software selects the lowest IP address

among the dynamic IP addresses. If there are no dynamic addresses, the

software selects the lowest IP address among the static IP addresses.

interface-id

mode)). Specifies that the software automatically selects a management

address to advertise from the IP addresses that are configured on the

interface ID. In case of multiple IP addresses, the software selects the

lowest IP address among the dynamic IP addresses of the interface. If there

are no dynamic addresses, the software selects the lowest IP address

among the static IP addresses of the interface. The interface ID can be one

of the following types: Ethernet port, port-channel or VLAN. Note that if the

port or port- channel are members in a VLAN that has an IP address, that

address is not included because the address is associated with the VLAN.

Default Configuration

No IP address is advertised.

The default advertisement is automatic.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

Each port can advertise one IP address.

The following example sets the LLDP management address advertisement mode

to automatic on gi2.

switchxxxxxx(config)#

switchxxxxxx(config-if)#

—(Available only when the device is in Layer 3 (router

interface gi2

lldp management-address automatic