Lldp Optional-Tlv - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
37
Link Layer Discovery Protocol (LLDP) Commands
Syntax
seconds
lldp tx-delay
no lldp tx-delay
Parameters
seconds
tx-delay
—Specifies the delay in seconds between successive LLDP
frame transmissions initiated by value/status changes in the LLDP local systems
MIB (range: 1-8192 seconds).
Default Configuration
The default LLDP frame transmission delay is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
It is recommended that the tx-delay be less than 0.25 of the LLDP timer interval.
Example
The following example sets the LLDP transmission delay to 10 seconds.
switchxxxxxx(config)#
10
lldp tx-delay
37.8
lldp optional-tlv
Use the lldp optional-tlv Interface Configuration (Ethernet) mode command to
specify which optional TLVs are transmitted. Use the no form of this command to
restore the default configuration.
For 802.1, see the
lldp optional-tlv 802.1
command.
Syntax
tlv
tlv2
tlv5
none
lldp optional-tlv
[
...
|
]
606
78-21075-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
