Lldp Reinit; Lldp Tx-Delay - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Link Layer Discovery Protocol (LLDP) Commands
78-21075-01 Command Line Interface Reference Guide
Example
The following example sets the LLDP packet hold time interval to 90 seconds.
switchxxxxxx(config)#
switchxxxxxx(config)#
37.6
lldp reinit
Use the lldp reinit Global Configuration mode command to specify the minimum
time an LLDP port waits before reinitializing LLDP transmission. Use the no form of
this command to revert to the default setting.
Syntax
lldp reinit
seconds
no lldp reinit
Parameters
reinit
seconds
—Specifies the minimum time in seconds an LLDP port waits before
reinitializing LLDP transmission.(Range: 1–10)
Default Configuration
2 seconds
Command Mode
Global Configuration mode
Example
switchxxxxxx
(config)# lldp reinit 4
37.7
lldp tx-delay
Use the lldp tx-delay Global Configuration mode command to set the delay
between successive LLDP frame transmissions initiated by value/status changes
in the LLDP local systems MIB. Use the no form of this command to restore the
default configuration.
lldp timer
30
lldp hold-multiplier
3
37
605
Advertisement
Table of Contents
