Cisco 300 Series Cli Manual page 417
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Address Table Commands
78-21075-01 Command Line Interface Reference Guide
Syntax
bridge multicast ipv6 forbidden ip-address {
remove} {ethernet interface-list | port-channel port-channel-list}
no bridge multicast ipv6 forbidden ip-address {
Parameters
•
ipv6-multicast-address—Specifies the group IPv6 Multicast address.
•
add—Forbids adding ports to the group.
•
remove—Forbids removing ports from the group.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel
port-channel-list
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
The default option is add.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers an IPv6 Multicast address, and forbids the IPv6
address on port
9 within VLAN 8.
gi
switchxxxxxx(config)#
switchxxxxxx(config-if)#
ipv6-multicast-address
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
8
interface vlan
bridge multicast ipv6 ip-address
}
ipv6-multicast-address
FF00:0:0:0:4:4:4:1
29
{add |
}
417
Advertisement
Table of Contents
