Dot1X Timeout Supp-Timeout - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
802. 1 X Commands
78-21075-01 Command Line Interface Reference Guide
Example
The following example sets the maximum number of times that the device sends
an EAP request/identity frame to 6
switchxxxxxx(config)#
switchxxxxxx(config-if)#
22.10 dot1x timeout supp-timeout
Use the dot1x timeout supp-timeout Interface Configuration (Ethernet) mode
command to set the time interval during which the device waits for a response to
an Extensible Authentication Protocol (EAP) request frame from the client before
resending the request. Use the no form of this command to restore the default
configuration.
Syntax
dot1x timeout supp-timeout
no dot1x timeout supp-timeout
Parameters
seconds
supp-timeout
device waits for a response to an EAP request frame from the client before
resending the request. (Range: 1–65535 seconds)
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
interface gi15
dot1x max-req
6
seconds
—Specifies the time interval in seconds during which the
22
327
Advertisement
Table of Contents
