Sntp Client Enable (Interface) - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Clock Commands
78-21075-01 Command Line Interface Reference Guide
Example
The following example enables the SNTP Broadcast and Anycast client on port
gi3.
switchxxxxxx(config)#
7.12
sntp client enable (Interface)
To enable the SNTP Broadcast and Anycast client on an interface, use the sntp
client enable Interface Configuration command. Use the no form of this command
to disable the SNTP client.
This command enables the SNTP Broadcast and Anycast client on an interface.
Use the no form of this command to disable the SNTP client.
Syntax
sntp client enable
no sntp client enable
Parameters
N/A
Default Configuration
The SNTP client is disabled on an interface.
Command Mode
Interface Configuration (Ethernet, Port-channel, VLAN) mode
User Guidelines
The
sntp broadcast client enable
enables Broadcast clients.
Example
The following example enables the SNTP Broadcast and Anycast client on an
interface.
switchxxxxxx(config-if)#
sntp client enable gi3
Global Configuration mode command globally
sntp client enable
7
145
Advertisement
Table of Contents
