Removing Ac Power Supply From The Cisco Asr 1001 Router - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing AC Power Supply from the Cisco ASR 1001 Router

Turn off the circuit breaker to the power supply.

For easier installation, plug the power cable into the inlet on power supply slot 1 first.

Insert the power supply cable into the power supply in slot 0 on the left.

Ensure that the AC power cords are positioned, as shown in the following figure.

Figure 302: Correct Position of the Cisco ASR 1001 Router AC Power Supply Cables

Plug the AC power supply cables into the AC power source.

Turn on the AC breaker.

Turn the Standby switch to On (|) on the chassis.

The power supply LEDs illuminate green.

What to Do Next

This completes the procedure for connecting AC-input power.

Removing AC Power Supply from the Cisco ASR 1001 Router

This section describes how to remove an AC power supply from the Cisco ASR 1001 Router. The Cisco ASR

1001 Router has two power supply slots, slot 1 next to the Standby switch and power supply slot zero (PS0)

to the left. Follow these steps:

Cisco ASR 1000 Series Router Hardware Installation Guide

AC power supply in PS0

Position of power supply

cable from PS0

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

AC power supply in PS1

Show Quick Links

Table of Contents