Cisco ASR 1013 Hardware Installation Manual page 301

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1002 Router Overview and Installation

Remove the covering from exactly the specified length of each wire. If you strip too much of the covering,

exposed wire protruding from the terminal block will create an electrical hazard. If you strip too little of the

covering, the wire might not make a good contact with the terminal, or it might not be held securely in place

in the terminal.

Using a 3.5mm screwdriver, insert the screwdriver at an angle to release the spring while you install the stripped lead

wire as shown in the image.

Figure 108: Inserting a Screwdriver Into the +24 VDC Power Supply Terminal Block

Carefully push the screwdriver at an angle forward until you relieve the spring contact.

With the screwdriver still inserted, gently push the lead wire (ground lead first) in until the copper wire, as shown in the

image, is no longer visible (see in the following image).

Check that there is no copper portion of the lead wire exposed. You only want the wire insulation visible.

Lead wire stripping area

Cisco ASR 1000 Series Router Hardware Installation Guide

Connecting Cisco 24 VDC Power Supply

Show Quick Links

Table of Contents

Troubleshooting