Cisco ASR 1013 Hardware Installation Manual page 514

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing the Cisco ASR1000-RP1 Module Internal Hard Drive

The following figure shows the Cisco ASR1000-RP1 module with the hard drive cover removed.

Figure 228: Cisco ASR1000-RP1 Module Hard Drive Cover and Screw Fastener

Remove the internal drive cover:

a) Using a # 2 Phillips screwdriver or a flat head screwdriver, loosen the screw fasteners on the cover.

b) Slide the cover off as shown in xref Figure 14-2.

c) Lift the cover up from the board.

Inspect the existing cables and replace them only if they are damaged. If you do not need to replace them, leave the

connection to the Cisco ASR 1000 Series Route Processor 1 in place and only remove the connection to the internal hard

Carefully disconnect the cables at the rear of the hard drive. These cables are tie-wrapped in to prevent them from

disconnecting from the Cisco ASR 1000 Series RP1 itself. If the cables are not damaged, leave the cables connected to

the Cisco ASR 1000 Series RP1 with the tie wrap in place. Remove the old hard drive.

Cisco ASR 1000 Series Router Hardware Installation Guide

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Show Quick Links

Table of Contents

Troubleshooting