Connecting A Cable To The Management Ethernet Port; Connecting Power To The Cisco Asr 1002-F Router - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Connecting a Cable to the Management Ethernet Port

After you establish normal router operation, you can disconnect the console terminal.

What to Do Next

A connection will not be established when setting up an out-of-band connection or modem connection in

the auxiliary port and the console port.

This section describes how to attach a cable to the Cisco Management Ethernet port on the Cisco ASR 1002-F

Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see ).

Figure 136: Cisco ASR 1002-F Router Integrated RP Management Ethernet Port Connector

Insert the other end of the RJ-45 cable into your management device or network.

Configure the port connection to a fixed speed through the command-line interface (CLI).

The covers are an integral part of the safety design of the product. Do not operate the unit without the

covers installed in empty slots. Statement 1077

When you install the unit, the ground connection must always be made first and disconnected last. Statement

Cisco ASR 1000 Series Router Hardware Installation Guide

Cisco ASR 1002-F Router Overview and Installation

Management Ethernet port

Show Quick Links

Table of Contents