Cisco ASR 1013 Hardware Installation Manual page 643

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

mm). Do not strip more than the recommended length of wire because doing so could leave the wire exposed from the

terminal block plug. The following figure shows a stripped DC input power source wire.

Figure 307: Stripping the DC Input Power Source Wire

An exposed wire lead from a DC input power source can conduct harmful levels of electricity. Be sure that

no exposed portion of the DC input power source wire extends from the terminal block plug. Statement 122

Identify the positive, negative, and ground feed positions for the terminal block connection. The recommended wiring

sequence is:

a) Ground lead wire (right)

b) Positive (+) lead wire (middle)

c) Negative (–) lead wire (left)

The following figure shows the DC power supply with lead wires.

Figure 308: DC Power Supply with Lead Wires

0.39 inch (10 mm) is the recommended wire-strip length

for the connector plug that has raised screw holes. 0.27

inch (7 mm) is the recommended wire-strip length for the

connector plug that does not have raised screw holes.

Negative (–) lead wire

Cisco ASR 1000 Series Router Hardware Installation Guide

Removing DC Input Power from the Cisco ASR 1001 Router

Ground lead wire

Show Quick Links

Table of Contents

Troubleshooting