Replacing The Cisco Asr 1001 Router Dimm - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

d) Place the cover aside while wearing an antistatic device, such as a wrist strap.

Position the chassis so that you are facing the front of the chassis to remove the DIMM.

Locate the DIMM on the ASR 1001 Router. See Figure 14-20, callout 1.

Pull down the lever on the DIMM socket to release the corresponding DIMM from the socket. See the following figure.

Figure 248: DIMM Socket Release Lever to Remove the DIMM from the Cisco ASR 1001 Router

When one end of the DIMM is released from the socket, grasp each end of the DIMM with your thumb and forefinger

and pull the DIMM completely out of the socket. Handle only the edges of the DIMM; avoid touching the memory

module, pins, and the metal traces (the metal fingers along the connector edge of the DIMM) along the socket edge.

Place the DIMM in an antistatic bag to protect it from ESD damage.

Repeat Step 8 through Step 10 for the remaining DIMMs if required for your upgrade.

What to Do Next

This completes the steps for removing the Cisco ASR 1001 Router DIMMs from the chassis.

Replacing the Cisco ASR 1001 Router DIMM

This section lists the steps to replace a DIMM into the Cisco ASR 1001 Router.

Removing and Replacing the Cisco ASR 1001 Router DIMM Memory Modules

Cisco ASR 1000 Series Router Hardware Installation Guide

Show Quick Links

Table of Contents