Cisco ASR 1013 Hardware Installation Manual page 622

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing an AC Power Supply in Cisco ASR 1013 Router

DETAILED STEPS

Slip on the ESD-preventive wrist strap that was included in the accessory kit.

Before you turn off a power supply, make certain the chassis is grounded.

Turn the power supply standby switch to the Standby position. See the following figure.

Figure 293: Cisco ASR 1013 Router AC Power Inlet and Standby Switch

Cisco ASR 1000 Series Router Hardware Installation Guide

AC power supply fan

DB-25 alarm connector*

Cable tie wrap tabs

AC power supply captive

AC power supply handle

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

AC power inlet

AC power supply standby

switch. A standby switch is

not considered a disconnect.

Protective sides around the

standby switch

AC power supply LEDs

Show Quick Links

Table of Contents

Troubleshooting