Cisco ASR 1013 Hardware Installation Manual page 618

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing a +24 VDC Power Supply in Cisco ASR 1002 Router

After the lead wire is fully inserted, hold the lead wire in place by pressing inward while you remove the screwdriver to

release the spring to tension down on the installed lead wire, then perform these steps:

a) Hold the lead wire in place while you are removing the screwdriver.

b) Once the screwdriver is completely removed, gently pull on the lead wire to make certain that the lead wire is securely

The following figure shows a lead wire fully inserted and the screwdriver removed while you gently pull on the lead

to make certain it is secured in the terminal block.

Figure 290: Removing a Screwdriver from the +24 VDC Power Supply Terminal Block

Cisco ASR 1000 Series Router Hardware Installation Guide

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Gently pull on lead wire.

Show Quick Links

Table of Contents

Troubleshooting