Connecting The Shared Port Adapter Cables; Connecting The Console And Auxiliary Port Cables - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1013 Router Overview and Installation

Connecting the Shared Port Adapter Cables

The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1013 Router

are contained in the respective configuration documents for each port adapter. For example, if you are

connecting the optical fiber cables for the PA-POS-OC3 port adapter, see PA-POS-OC3 Port Adapter

Installation and Configuration at the following location:

http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/

pa-pos-oc3_install_config/paposoc3.html

Shared port adapter documents are also available on the Cisco Documentation DVD.

The Cisco ASR 1013 Router has a DCE-mode console port for connecting a console terminal and an auxiliary

port for additional connections to your chassis. The auxiliary port can also be used for diagnostics.

In a fully redundant chassis, each Cisco ASR1000-RP2 is separately connected to each FP and I/O card slot

over separate point-to-point connections of the system interconnect over the midplane. The selection of the

active RP2s is made separately from the selection of the active embedded services processor.

The following image shows the Cisco ASR 1000 Series Route Processor faceplate.

Figure 187: Cisco ASR1000-RP2 Faceplate LEDs

Internal hard drive LED

External USB Flash LED

Internal USB bootflash

Cisco ASR 1000 Series Router Hardware Installation Guide

USB 0, USB 1 connector

ASR1000-RP2 LEDs

Show Quick Links

Table of Contents