Table of Contents
Advertisement
Chapter 6
Cisco ASR 1006 Router Overview and Installation
Use the following procedure to attach the grounding lug to the chassis ground connector on your chassis:
Use the wire stripper to strip one end of the AWG #6 wire approximately 0.75 inches (19.05 mm).
Step 1
Insert the AWG #6 wire into the wire receptacle on the grounding lug.
Step 2
Use the crimping tool to carefully crimp the wire receptacle around the wire; this step is required to
Step 3
ensure a proper mechanical connection.
Attach the grounding lug with the wire so that the grounding wire does not overlap the power supply (see
Step 4
Figure
Figure 6-14
1
2
Step 5
Locate the chassis ground connector on the side of your chassis.
Step 6
Insert the two screws through the holes in the grounding lug.
Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held
Step 7
firmly to the chassis. Do not overtighten the screws.
Step 8
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure
an adequate chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the following cabling
sections for information on attaching cables.
Connecting the Shared Port Adapter Cables
The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1006
Router are contained in the respective configuration documents for each port adapter. For example, if
you are connecting the optical fiber cables for the PA-POS-OC3 port adapter, see PA-POS-OC3 Port
Adapter Installation and Configuration at the following location:
http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/pa-po
s-oc3_install_config/paposoc3.html
OL-13208-09
6-14).
Attaching a Grounding Lug to the Chassis Ground Connector
1
Chassis ground lead wire
Grounding stud
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
3
2
4
3
Ground screws
4
Chassis ground connector holes
Connecting the Shared Port Adapter Cables
6-21
- Quick Links:
- Front View
Hide quick links:
Advertisement
Table of Contents
