Rack-Mounting The Cisco Asr 1013 Router; Verifying Rack Dimensions - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Rack-Mounting the Cisco ASR 1013 Router

Position the rear rack-mount bracket top hole with the chassis second top hole from the back.

Insert and tighten the screws on one side.

After the bracket is secured to the side of the chassis, slide the two remaining components into the side rack-mount

Repeat Step 1 through Step 3 on the other side of the chassis. Use all the screws to secure the rear rack-mount brackets

to the chassis.

What to Do Next

This completes the steps for attaching the rear rack-mount brackets to the Cisco ASR 1013 Router.

The Cisco ASR 1013 Router comes installed with front forward rack-mount brackets. The rear rack-mount

brackets are optional and are shipped in the accessory kit along with a set of front rack-mount brackets. The

chassis rack-mounting flanges must be secured directly to the chassis before you lift it into the rack.

This section includes the following topics:

Before you install the chassis, measure the space between the vertical mounting flanges (rails) on your

equipment rack to verify that the rack conforms to the measurements shown in the following image.

Figure 181: Verifying Equipment Rack Dimensions

SUMMARY STEPS

1. Mark and measure the distance between two holes on the left and right mounting rails.

2. Measure the space between the inner edges of the left front and right front mounting flanges on the

equipment rack.

Cisco ASR 1000 Series Router Hardware Installation Guide

Cisco ASR 1013 Router Overview and Installation

Show Quick Links

Table of Contents