Installation Methods; General Rack Installation Guidelines - Cisco ASR 1013 Hardware Installation Manual
Asr 1000 series
Hide thumbs
Also See for ASR 1013:
- Installation manual (42 pages) ,
- Quick start manual (37 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Cisco ASR 1001 Router Overview and Installation
Power Cord Item Number
CAB-ACR-RA
CAB-ACS-RA
CAB-ACU-RA
CAB-IND-RA
CAB-JPN-RA
Installation Methods
Cisco ASR 1001 Router is designed for standalone, two rail 19-inch rack-mount (front rail only), four rail
19-inch rack-mount (front and rear rail).
Although rack-mounting is the preferred method of installation for the Cisco ASR 1001 Router, you can
mount the chassis on an equipment shelf or tabletop.
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
Warning
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
Before you install, operate, or service the system, read the Regulatory Compliance and Safety Information
Warning
for Cisco ASR 1000 Series Aggregation Services Routers publication. This document provides important
safety information you should know before working with the system. Statement 200
You have already unpacked your chassis and read all the site requirements for your new equipment.
Note
Proceed with the installation.
General Rack Installation Guidelines
When planning your rack installation, consider the following guidelines:
• The Cisco ASR 1001 Router requires a minimum of 3.5 inches or 8.9 cm rack units of vertical rack
• Before using a particular rack, check for obstructions (such as a power strip) that could impair rack-mount
space. Measure the proposed rack location before mounting the chassis in the rack.
installation. If a power strip does impair a rack-mount installation, remove the power strip before installing
the chassis, and then replace it after the chassis is installed.
Description
Power Cord Argentina, Right Angle
Power Cord, Switzerland, Right Angle
Power Cord UK, Right Angle
Power Cord India, Right Angle
Power Cord-Japan, Right Angle
Cisco ASR 1000 Series Router Hardware Installation Guide
Installation Methods
425
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
