Verifying Rack Dimensions - Cisco ASR 1013 Hardware Installation Manual
Asr 1000 series
Hide thumbs
Also See for ASR 1013:
- Installation manual (42 pages) ,
- Quick start manual (37 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Verifying Rack Dimensions
If you are using a two-post rack, secure the rack to the floor surface to prevent tipping and avoid bodily
Note
injury.
• Four-post, 19-inch equipment rack. Inner clearance (the width between the inner sides of the two posts
The Cisco ASR 1002-F Router can be installed with both front or rear rack-mount brackets.
Verifying Rack Dimensions
Before you install the chassis, measure the space between the vertical mounting flanges (rails) on your
equipment rack to verify that the rack conforms to the measurements shown in the following image.
SUMMARY STEPS
1. Mark and measure the distance between two holes on the left and right mounting rails. The distance should
measure 18.31 inches ± 0.06 inches (46.5 cm ± 0.15 cm).
2. Measure the space between the inner edges of the left front and right front mounting flanges on the
equipment rack. The space must be at least 17.7 inches (45 cm) to accommodate the chassis, which is
17.25 inches (43.8 cm) wide and fits between the mounting posts on the rack.
DETAILED STEPS
Step 1
Mark and measure the distance between two holes on the left and right mounting rails. The distance should measure
18.31 inches ± 0.06 inches (46.5 cm ± 0.15 cm).
Note
Measure for pairs of holes near the bottom, middle, and top of the equipment rack to ensure that the rack posts
are parallel.
Step 2
Measure the space between the inner edges of the left front and right front mounting flanges on the equipment rack. The
space must be at least 17.7 inches (45 cm) to accommodate the chassis, which is 17.25 inches (43.8 cm) wide and fits
between the mounting posts on the rack.
Figure 126: Verifying Equipment Rack Dimensions
Cisco ASR 1000 Series Router Hardware Installation Guide
292
or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches/8.8 cm). Airflow
through the chassis is from front to back.
Cisco ASR 1002-F Router Overview and Installation
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
